Downloaded from www.vandenborre.be
9
MAINTENANCE
Drainage
Before the air conditioner is turned on, you can insert the rubber plug to the drain or attach the supplied drain hose to
the drain hole.
A. Rubber plug
B. Drain hole
C. Rubber plug for drain hose
D. Hose clamp (2)
E. Bracket
Use the supplied screw to fix the bracket to the unit.
F. Drain hose
When the tank is full, “H8” will be shown on the display.
1. Turn off the unit.
2. Position a container under the drain hole.
3. Remove the rubber plug from the drain hole or hose. The condensed water will drain out.
4. Once all the condensed water has been removed, replace the rubber plug into the drain hole or hose firmly.
• The full water indicator light “H8” will disappear on the display.
Cleaning the Housing
Always unplug the unit from the mains before cleaning.
Wipe the housing with a damp cloth.
Do not use chemical solvents or strong detergents as these may damage the cosmetic finish.