Why does my PROLiNK EnerHome PRO PRO700 UPS beep occasionally and feel hot?
Your PROLiNK UPS may be beeping and heating up due to being overloaded. Check that your equipment's power requirements do not exceed the UPS's specified capacity. Also, the AC supply might be unstable. In this case, a qualified electrician should inspect your AC supply and wiring.
What to do if my PROLiNK EnerHome PRO PRO700 UPS battery backup time is short?
If the battery backup time of your PROLiNK UPS is short and you hear beeping every second, try these steps: First, remove any non-critical equipment to reduce the load. Second, ensure the battery is fully charged by charging it for at least 8 hours. If the problem persists, the battery may be nearing the end of its lifespan, and you should contact your supplier for a replacement, noting that charges may apply.
How to fix a PROLiNK EnerHome PRO PRO700 when the green light is off, the yellow light is blinking, and it's beeping?
If the green LED on your PROLiNK UPS doesn't light up when turned on, the yellow LED is blinking, and the unit is beeping, check the following: 1. Ensure the AC power is on. 2. Verify the power cable is properly inserted. 3. Check and change the fuse, if it's blown. 4. Try a different wall socket to rule out a faulty one.
Step-by-step guide for connecting and operating the UPS unit.
Table detailing UPS status, buzzer, and LED indications for different modes.
Explanation of the front and rear panel components and their functions.
Common problems, their possible causes, and recommended solutions for the UPS.
Contact numbers for technical support in Singapore, Malaysia, and Indonesia.
Email address for online technical support queries.
General| Output Power | 420 W |
|---|---|
| Output Voltage | 230VAC ± 10% |
| Number of Outlets | 4 |
| Output Waveform | Simulated Sine Wave |
| Communication Port | USB |
| Capacity | 700VA |
| Input Voltage | 230VAC |
| Input Voltage Range | 162 ~ 290VAC |
| Frequency | 50/60 Hz |
| Battery Type | 12V/7Ah |
| Typical Recharge Time | 4-6 hours to 90% |
| Transfer Time | 2-6ms |
| Dimensions | 279 x 101 x 142 mm |
To Next Page