Need help?Do you have a question about the PROLiNK PRO1201SFCU and is the answer not in the manual?
General| Model | PRO1201SFCU |
|---|---|
| Capacity | 1200VA/720W |
| Input Voltage | 220/230/240VAC |
| Output Voltage | 220/230/240VAC |
| Waveform (Battery Mode) | Simulated Sine Wave |
| Battery Backup Time | Up to 30 minutes (depending on load) |
| Indicators | AC Mode, Battery Mode, Low Battery, Overload, Fault |
| Alarm | Battery Mode, Low Battery, Overload, Fault |
| Full Protection | Overload, Discharge, and Overcharge Protection |
| Form Factor | Tower |
| Input Frequency | 50/60Hz |
| Output Frequency | 50/60Hz |
| Transfer Time (Typical) | 2 - 6ms |
| Typical Recharge Time | 4-6 hours |
| Operating Temperature | 0°C - 40°C |
| Humidity | 0% - 90% RH (Non-condensing) |
| Noise Level | Less than 40dB |
| Communication Port | USB |
Connect the UPS to a wall outlet and charge the battery for at least 6 hours before initial use.
Install the UPS in a clean, well-ventilated area away from heat and interference.
Connect devices to UPS output, surge-protect phone/network lines, and connect communication cable.
Instructions on how to power the UPS unit on and off using the power switch.
To Next Page