Need help?Do you have a question about the PROLiNK PRO700C and is the answer not in the manual?
Connect to AC power and charge the battery for at least 6 hours prior to initial use for best results.
Install the UPS in a protected, ventilated area, at least 20 cm away from other units.
Plug connected devices into the UPS output receptacles and turn on the unit.
Operate the UPS by pressing the power switch to turn the unit on or off.
General| Capacity | 700VA / 360W |
|---|---|
| Input Voltage | 230VAC |
| Output Voltage | 230VAC |
| Waveform | Simulated Sine Wave |
| Battery Recharge Time | 4-6 hours recover to 90% capacity |
| Form Factor | Tower |
| Operating Temperature | 0°C to 40°C |
| Input Frequency | 50/60Hz |
| Output Frequency | 50/60Hz |
| Battery Type | 12V / 7Ah |
| Communication Interface | USB |
| Storage Temperature | -15°C to 45°C |
| Humidity | 0% to 90% non-condensing |
| Transfer Time | Typical 2-6ms |
To Next Page