To Next PageTo Next Page
Need help?Do you have a question about the PROLiNK PRO700SFT and is the answer not in the manual?
General| Input Voltage | 220/230/240 VAC |
|---|---|
| Output Voltage | 220/230/240 VAC |
| Transfer Time (Typical) | 2-6 ms |
| Waveform (Battery Mode) | Simulated Sine Wave |
| Typical Recharge Time | 4-6 hours recover to 90% capacity |
| Number of Outlets | 2 |
| Operating Temperature | 0°C to 40°C |
| Weight | 4.3 kg |
| Form Factor | Tower |
| Power Rating | 700VA |
| Capacity | 700VA |
| Input Frequency | 50/60 Hz (Auto Sensing) |
| Output Frequency | 50 or 60Hz ± 1 Hz |
| Battery Type | 12V/7Ah x 1 |
| Back-up Time (Half Load) | 8 minutes |
| Operating Relative Humidity | 0 to 90% |
| Transfer Time | 4ms |
| Battery | 12V/7Ah |
| Humidity | 20% to 90% |
| Battery Backup Time | 8 minutes (Half Load) |
| Indicators | AC Mode, Battery Mode, Battery Fault |
Covers essential safety guidelines for UPS installation and operation to prevent hazards.
Instructions for connecting the UPS to AC power and initial battery charging.
Guidelines for optimal UPS placement and environmental conditions for safe operation.
How to connect electrical devices to the UPS output receptacles.
Addressing causes for short backup time when power fails.
Responds to F01 error code indicating a short circuit on output.
