PROLiNK PRO700SFT - LCD Operation; AC Mode; Battery Mode; Overload Conditions

EN 5
Note:
If backlight shuts off, you may activate it by touching the screen.
5. LCD Operation
UPS Mode
LCD
Description
UPS Power on
When UPS is powered on, it will
enter this mode for few seconds.
Standby Mode
Only input voltage is disp layed even
LCD is touched again.
AC Mode
When AVR is functioning,
icon will flash every second.
LCD information will be displayed in
the following order when LCD is
touched.
1. Output voltage
2. Input voltage
3. Load level
4. Battery voltage
Overload in AC
mode
icon will flash.
When overload occurs, alarm will
beep every 0.5 second.
Battery Mode
When battery level is low,
icon will flash.
Alarm will beep every 10 seconds
and LCD information will be
displayed in the following order
when LCD is touched.
1. Output voltage
2. Input voltage
3. Load level
4. Battery voltage
Overload in
battery mode
icon will flash.
When overload occurs, alarm will
beep every 0.5 second.