Promise Technology VTrak N1008 - Page 15

12
Promise Technology VTrak N1008
Inordertousetheweb-basedmanagementinterface,WebPAMInsight,itisnecessarytoconnectthe
VTrak N1008 to the same switched network as the computer used to manage the system. Note that this
isanoptionalstep,sincethedeviceisreadytouseasshipped.However,someadvancedconguration
optionscanonlybeaccessedusingtheWebPAMInsightinterface.
5 Connect 1G Network WebPAM Insight Management
TocompletethephysicalconnectiontotheWebPAMInsightmanagementinterface,connectthecomputer
usedforVTrakN1008managementtoa1Gnetworkswitch,andconnecteitherofthe1Gnetworkportsto
the same switch or switched network.
Also keep in mind that both the management computer and VTrak N1008 must be in the same IP subnet.
IfyournetworkhasDHCPservice,thisiseasilydonebysettingthecomputerIPsettingtoDHCPclient.
1G ports on back of VTrak N1008
#2 #1
Connect either 1G
port to 1G network for
system management
using WebPAM Insight.
The default IP settings on the 1G network interface is DHCP client. If your
network used for management has an active DHCP service, use DHCP on the
computer used for management to simplify IP settings on both systems.