PROPAIN HUGENE - Page 12

// BEFORE YOUR FIRST RIDE
ÐåďīÐřďķīťīĮĴīðÌÐșÆìÐÆāăăÅĮðÆåķĊÆĴðďĊĮďåřďķīÅðāÐĴďÐĊĮķīÐĴìĴĴìÐīÐīÐĊďĮĮÐĉÅăřÐīīďīĮďīĴīĊĮĨďīĴÌĉæÐĮȘAåĴìÐīÐīÐĊřÌÐåÐÆĴĮďīŦœĮșřďķĮìďķăÌìŒÐřďķīÅðāÐðĊĮĨÐÆĴÐÌĊÌ
īÐĨðīÐÌÅřĪķăðťÐÌÅðÆřÆăÐĉÐÆìĊðÆȘUÐŒÐīīðÌÐœðĴìÌÐåÐÆĴðŒÐÅðāÐȝ
WHEELS / TIRES
Lift the wheels one after the other and spin them.
ĺ The wheels must spin smoothly.
ĺ }ìÐœìÐÐăĮĉķĮĴīķĊĴīķÐșœðĴìďķĴĉďŒðĊæķĨĊÌÌďœĊďīåīďĉĮðÌÐĴďĮðÌÐȘ
ĺ The tires must not rub against the frame.
Check the tire pressure.
ĺ The tire pressure should be about 2 bar. The maximum tire pressure of the wheel and of the tire used must not be exceeded.
Check the tightening torque of the thru axles.
ĺ }ìÐăÐŒÐīďåĴìÐĴìīķŘăÐďåĴìÐåīďĊĴœìÐÐăĉķĮĴÅÐÆăďĮÐÌťīĉăřȝ
ĺ The thru axle of the rear wheel must be tightened to 12 Nm!
COMPONENTS
ÐīðåřĴìÐĴðæìĴťĴďåĴìÐĮĴÐĉȚwĴĊÌðĊåīďĊĴďåĴìÐÅðāÐœðĴìĴìÐåīďĊĴœìÐÐăÅÐĴœÐÐĊřďķīāĊÐÐĮĊÌĴīřĴďĴķīĊĴìÐìĊÌăÐÅīăÐåĴĊÌīðæìĴȘ
ĺ It should not be possible to turn the handlebar with normal force.
ìÐÆāĴìÐìÐÌĮÐĴåďīĨăřȚwĴĊÌĊÐŘĴĴďřďķīÅðāÐșĨķăăĴìÐåīďĊĴÅīāÐăÐŒÐīĊÌæÐĊĴăřĨķĮìĴìÐÅðāÐÅÆāœīÌĮĊÌåďīœīÌĮȘ
ĺ No bearing play must be detectable.
Make sure that all components are tight.
ĺ }ðæìĴÐĊĴìÐĨīĴĮĴďĴìÐĨīďĨÐīĴďīĪķÐșðåĊÐÐÌÅÐȘAĊÆĮÐďåÌďķÅĴșÆďĊĴÆĴĴìÐqīďĨðĊwÐīŒðÆÐȘ
FRAME
Check the frame for damages and deformation.
ĺ There must be no damages.
FORK /
SHOCK
wðĴďĊĴìÐÅðāÐœðĴìăăřďķīÆřÆăðĊæÐĪķðĨĉÐĊĴȧìÐăĉÐĴșÅÆāĨÆāșĮìďÐĮșÐĴÆȘȨĊÌĴāÐĊďīĉăīðÌðĊæĨďĮðĴðďĊȘ
ĺ We recommend a SAG of 15% - 20% on the fork and 20% - 30% on the shock.
ĺ AåĊÐÆÐĮĮīřșÆìĊæÐĴìÐðīĨīÐĮĮķīÐďåřďķīĮķĮĨÐĊĮðďĊÐăÐĉÐĊĴĮȘAåřďķìŒÐďīÌÐīÐÌĮìďÆāœðĴìĮĴÐÐăĮĨīðĊæřďķìŒÐăīÐÌřÆìďĮÐĊĮĨīðĊæīĴÐÆďīīÐĮĨďĊÌðĊæĴď
your weight. Details can be found in the user manual of your bike.
BRAKES
ìÐÆāÅīāÐÐŨÆðÐĊÆřȚqķăăďĊÐÅīāÐăÐŒÐīåĴÐīĴìÐďĴìÐīœìðăÐĮĴĊÌðĊæĊÌĨķĮìĴìÐÅðāÐÅÆāœīÌĮĊÌåďīœīÌĮȘ
ĺ The front and rear wheel must lock when the brake lever is pulled.
ìÐÆāœìÐĴìÐīĴìÐÅīāÐìďĮÐĮĊÌÆďĊĊÐÆĴðďĊĮīÐăďĮðĊæÅīāÐŦķðÌĊÌÆìÐÆāĴìÐĉåďīÌÐåÐÆĴĮȘ
ĺ īāÐŦķðÌĉķĮĴĊďĴÐĮÆĨÐĴĴìÐÆďĊĊÐÆĴðďĊĮȘ
Break in the brake pads. Choose a road away from public roads and brake 20 to 30 times with the front or rear brake from a speed of 30 km/h down to 5 km/h. You should brake as
hard as possible without locking one of the wheels. Repeat the process for the other brake. Only then the brake can show its full braking power.