PROPOINT 8561110 - Page 8

8561110
34° Clipped Head Framing Nailer
V1.0
8. Check operation of the tool before use. Do not use
the tool if the workpiece contact mechanism is not
working correctly as accidental driving of a fastener
may occur.
9. Do not use tool if trigger does not actuate properly.
Any tool that cannot be controlled with the trigger
is dangerous and must be repaired.
10. Do not force tool. Use the correct tool for your
application. The correct tool will do the job better
and safer at the rate for which it is designed.
11. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
a tool by hand or against the body is unstable and
may lead to loss of control.
12. Keep the tool and its handle dry, clean and free
from oil and grease. Always use a clean cloth when
cleaning. Never use brake fluids, gasoline,
petroleum-based products, or any strong solvents
to clean your tool.
13. Do not use the tool as a hammer.
14. Never use this tool in a manner that could cause a
fastener to be directed toward anything other than
the workpiece.
15. Never use gasoline or other flammable liquids to
clean the tool. Never use the tool in the presence of
flammable liquids or gases. Vapors could ignite by a
spark and cause an explosion which will result in
death or serious personal injury.
16.
Do not remove, tamper with, or otherwise cause the
trigger lock or trigger to become inoperable. Do
not operate any tool which has been modified in a
like fashion. Death or serious personal injury
could result.
8 For technical questions call 1-800-665-8685