17
MAINTENANCE & CARE
General cleaning will help prolong the life and performance of your treadmill. Keep the unit
clean and maintained by dusting the components on a regular basis. Clean both sides of
the running belt to prevent dust from accumulating underneath the belt. Keep your running
shoes clean so that dirt from your shoes does not wear out the running board and belt.
Clean the surface of the running belt with a clean damp cloth.
To better maintain the treadmill and prolong its life it is suggested that the machine be
powered off for 10 minutes every 2 hours and fully powered off whenever not in use.
A loose Running Belt will result in the runner sliding off when running, while too tight of a
Running Belt will result in decrease to the motors performance and also create more
friction between the roller and running belts. The most suitable tightness for the belts is
pulled out 50-75mm from the Running Board.
CENTERING THE RUNNING BELT:
Place the treadmill on level ground and set it at 6-8kph to check if the Running Belt drifts.
1. If the Running Belt moves to the right,
turn the adjusting bolt on the right side ¼
turn clockwise, then turn the left
adjustment bolt ¼ turn counter-clockwise.
If the belt does not move, repeat this step
until it centers. Refer to figure A.
2. If the Running Belt moves to the left,
turn the adjusting bolts on the left side ¼
of a turn clockwise, then turn the right
adjustment bolt ¼ turn counter-clockwise.
If the belt does not move, repeat this step
until it centers. Refer to figure B.
3. Over time the Running Belt will
loosen. To tighten the belt turn the Left &
Right side adjustment bolts one full turn
clockwise, check the tension of the belt.
Continue this process until belt is at the
correct tension. Make sure to adjust both
sides equally to ensure correct belt
alignment. Refer to figure C.
To Next Page
Loading...
