Proscend 5200N Series User Manual

G.SHDSL .bis Router User Manual V0.04
41
SNMP
Item Description
Port Enter port number for the SNMP service
Access Status Click on the drop-down list and select ALL to allow the service or Disable
WAN to disable the remote management service
SNMP Configuration
Item Description
Get Community Enter the password for the incoming Get and Get Next requests from the
management station. The default is public which allows all requests.
Set Community Enter the password for the incoming Set requests from the management
station. The default is public which allows all requests.
Trap Community Enter the password sent with each trap to the SNMP manager. The default
is public which allows all requests.
Trap Destination Enter the IP address of the station to send SNMP traps
Click on Apply to save the parameters or Cancel to start configuring this page from beginning.
4
4
.
.
1
1
.
.
2
2
.
.
2
2
W
W
W
W
W
W
Click WWW to configure the parameters for remote management via WWW
WWW
Item Description
Port Enter port number for remote management via WWW
Access Status Click on the drop-down list and select ALL to allow the service or Disable
WAN to disable the remote management service
4
4
.
.
1
1
.
.
2
2
.
.
3
3
T
T
E
E
L
L
N
N
E
E
T
T
Click TELNET to configure the parameters for remote management via TELNET

Proscend 5200N Series Specifications

General

Brand	Proscend
Model	5200N Series
Category	Network Router
Language	English