PROSOURCEFIT BALANCE TRAINER - Inflation Instructions; Step-by-Step Inflation Guide

INFLATION INSTRUCTIONS
STEP 1
Locate the blue air hose. Connect one
end of the hose to the blue nozzle on
the air pump. Make sure it is connected
tightly.
STEP 5
When finished pumping, insert ball air plug to complete inflation.
STEP 3
With balance trainer ball upside
down, locate inflation hole in center
of the base. Insert nozzle tip of hose
into inflation hole.
STEP 4
Step down on air pump to Inflate at
desired level. Recommended inflation
height is 8.5 to 10 inches. Do not
overinflate.
STEP 2
On the opposite side of the blue air
hose, insert the nozzle tip. Make sure it
is connected tightly. When connected,
place the cap on the nozzle tip.