11
6.2 Set Camera State
To set the number of pictures or movie the camera will take per PIR triggering. Select the Camera
State by sliding the “State” toggle switch
1P: Single image capturing per PIR triggering
3P: Three images continuous capturing per PIR triggering
Mov: 10~90 seconds video clip per PIR triggering (default is 15 seconds ex-factory)
6.3 Set Date, Year and Time
Setting the Date, Year and Time to make them stamp in the picture.
1) Set Date
a) Sliding the “Power” toggle switch to “On” then to “Set”.
b) Rotate the menu items by “UP” or “DOWN” button, until it shows “Set Date”
c) Press “OK” to enter the setting. It shows in “MM/DD”.
d) Press “UP” and “DOWN” to change the value of the “MM-month”, and press “OK” to
confirm the value and proceed to the next setting “DD-date”.
e) Press “UP” and “DOWN” to change the value of the date, and press “OK” to confirm the
value and proceed to the next setting “Set Year”. The year value is from 2008 to 2030.
f) Press “UP” and “DOWN” to change the value of year, and press “OK” to confirm the
value.
2) Set Time
a) Sliding the “Power” toggle switch to “On” then to “Set”
b) Rotate the menu items by “UP” or “DOWN” button, until it shows “Set Time”
c) Press “OK” to enter the setting. It shows in “HH/MM” (24H military time format).
d) Press “UP” and “DOWN” to change the value of “HH-hour”, and press “OK” to confirm
the value and proceed to the next setting.
e) Press “UP” and “DOWN” to change the value of “MM-minute”, and press “OK” to
confirm the value.
▲ Date & Time setting will be lost whenever the batteries are removed from camera. Don’t
forget to reset the Date & Time stamp after you replace the batteries.
6.4 Set Image Resolution
The resolution the user can select is listed below.
Model High Med Low
To Next Page
Loading...