ProStart CT-4211TW - Multi-Car Operation; Intrusion Codes Via Horn; Diagnostics Via Parking Lights; Diagnostic Table for Shutdown

Installation Guide P.29
Note: For Hardware 5.0 and higher, there can only be one bypass connected to the unit.
Multi-Car Operation
This option allows the owner of two vehicles, both equipped with identical systems, to control both systems with
only one remote transmitter. (See user guide for operation)
Note: See transmitter programming section on how to learn the transmitter to the second car.
Intrusion Codes via Horn
The system monitors the following:
• Doors
• Hood
• Ignition
Note: If an intrusion has occurred the HORN will sound for a maximum of 1minute.
If an intrusion has occurred and pressed, the horn provides an intrusion code corresponding to the type of
intrusion that occurred.
Diagnostic table:
1x = power interruption
4 x = Doors intrusion
3x = Hood
6x = Ignition
Diagnostics via Parking Lights
Diagnostic Table for Shutdown
Parking lights flashes
Cause
1
• Runtime has expired.
2
• Shutdown by remote.
• Ready mode is activated.
3
• Failed start.
4
• Brake shutdown.
10
• Hood shutdown.
Flash for 30sec
• Panic mode.
Flash for 60sec
• Alarm triggered.
Diagnostic Table for Start Failure
Parking lights flashes
Cause
0
• Ignition is active
1
(Manual transmission
only)
• Ready mode is not activated.
• Tach signal is not learned.
1 slow  2 quick
• The system is set to valet mode.
3
(Automatic transmission
only)
• The parking brake is active.
• Yellow loop is connected.
4
• Brake wire is active
6
• A tach signal is detected before Ignition.