5
1. Performance and Installation
1.1. Performance and Features
High Efficiency
With a COP value up to 5.0, our heat pumps are very efficient when transferring heat from the
air to the swimming pool water. You can save as much as 80% of cost compared to an
electrical heater.
Long lifespan
The heat exchanger is made of PVC with titanium tube, which enables it to withstand
prolonged exposure to swimming pool water.
Easy control and operation
The unit is very easy to operate: simply switch it on and set the desired pool water
temperature. The system is equipped with a micro-computer controller, allowing all operating
parameters to be set. Operation status can be displayed on the controller with LED display.
1.2 Working Principles
Heat pumps use heat from the sun by collecting and absorbing energy from the outside air.
This energy is then compressed and transferred to the pool water. Your existing water pump
circulates the water through the heat pump, which is normally installed next to the pool
filtration system, and the water warms up. The heat pump timer can be set so that the pump
operates at the times you want: for example, during daylight hours from 9am to 5pm.
The unit contains a fan that draws in outside air and directs it over the surface of the
EVAPORATOR (energy collector). The liquid refrigerant inside the EVAPORATOR coil
absorbs the heat from the outside air and becomes a gas.
The warm gas inside the coil passes through the COMPRESSOR, which concentrates
and increases the heat to form a very hot gas, which then passes through the
CONDENSER (water heat exchanger). It is here that the heat exchange occurs as the
To Next Page
Loading...