Step-1. Check the contents in the gift box.
After opening the gift box, you should check up and find the following items.
Digital HD-Receiver
Remote Control
User’s Guide
2 Batteries (AAA or LR03 size)
Step-2. Connect ANT Cable
Connect satellite antenna cable to LNB-IN of the HD-Receiver.
Connect another antenna cable between LOOP-OUT of other Receiver if applicable.
Step-3. Connecting the Video
Prepare TV or HDTV you want to connect.
There are several methods to connection of video. You should find correct connection
method for your HDTV. Please refer to article 2.2 Video connection diagram.
Step-4. Connecting the Audio
Prepare HDTV or Audio equipment you want to connect. If you are using HDMI connection,
you do not need audio connection.There are two different connection methods for Audio
connection. For general TV set with
analog audio connection, it has AUDIO L/R. For digital
audio connection, you should prepare Optical / Coaxial Audio cable for optical / Coaxial audio
connection with
Home Theater Equipment.
Step-5. Connecting the Power
Plug the Power Cord to wall AC outlet. The power source is AC 180-250V~, 50/60Hz. This unit is
designed for continuous operation.
Switching it off does not disconnect it from the AC outlet.
To disconnect this HD-Receiver from AC outlet, you have to unplug the HD-Receiver.
Step-6. Install the Remote Control batteries
1) Open the battery compartment on the back of the Remote Control.
2) Install two AAA or LR03 size batteries as shown. The battery has polarity so when insert
the batteries, make sure the `அ` and `இ` terminals are oriented correctly.
3) Replace the cover.
Note :
If you find missing or broken part, then ask to
supplier or contact to service center.
Step-7. Video Format Setting
For the Video Format Setting, Press the
button at the Remote Control for
video format change. The default video format is 1080i.
Step-8. Check up the On Screen Display
For verify correct setting of Video Format, you should check up the OSD from HDTV’s display
screen. Turn on the HD-Receiver and HDTV. Press button on the Remote Control, you
should check up the OSD for verify A/V connection. If you cannot find any OSD in your TV
display, please check up again the Video Format Setting and A/V connection.
Step-9. Select the satellite and Automatic Channel Search
Please select the satellite and perform the
Automatic Channel Search.
The HD-Receiver will
automatic starting the available channels. For doing proper channel search, you should refer to
article 4-3 Installation.
Step-10. Change Programs
You can change the program using P or P
button in your Remote Control. Or you can
direct
select the program with pressing the number button in your Remote Control.
MENU
6
3. Getting Started
Note :
Do not mix different types of batteries,
or mix an old and a new battery.
Remove and replace weak batteries.
Weak batteries can leak and damage
your remote controller.
Dispose batteries
properly, never throw
them into a fire.
To Next Page
Loading...
Need help?
General
