4-4. SmartCard
4-5. System Information
In this menu, you can check up the model name, current
software/ hardware version and upgrade latest firmware
through USB memory stick. Also you can import or export
channel list. For the firmware upgrade, please refer to the
Section 6. Firmware Upgrade.
Load Channel List from USB : Import channel lists from
USB memory stick which is previous saved channel lists.
Save Channel List to USB : Export current channel lists
to USB memory stick.
When saving channel list to USB, the file
name is automatic
created by current date and file extension will be ‘.cdb’.
4. Using the MENU System
10
Some broadcaster broadcast scrambled service and it
required paid subscription for watching TV. The scrambled
services can only be watched with subscription card. This
HD-Receiver has One Smart card slot
for insert the
Subscription Card. To watch a pay
service you should
take the following steps;
Step-1.
Check if subscription card of your provider is supported
by this HD-Receiver
Step-2. Purchase a subscription
card for the pay service which
you want to watch.
Step-3.
Insert the subscription card into the Smart card slot
Step-4.
Please make sure the card’s contact should be up
side down
By pushing USB key on remote control you can access Contents Browser, Connect or
Disconnect and Format your connected USB device.
4-6. USB Menu
4-6-1. Contents Browser. You can browse the content of the connected USB device.
4-6-2. Connect Drive
In normal case, user uses rarely this menu item when proper USB DISK connected to STB since
STB will find first proper partition and connect automatically. However, after change or format
the USB DISK, user should connect USB DISK by manually. In this situation user can select
partition if there are several partitions available.
4-6-3. Disconnect Drive
The STB communicate with USB DISK after proper USB connection made even though you do
not perform playing or recording. Thus if you disconnect the USB forcibly, it may cause USB DISK
corruption. For preventing it, you should
do disconnect drive process before you plug out USB
DISK from STB. When you switch off the STB power, disconnect operation will process automatically.
At that time, you don’t need disconnect operation manually.
4-6-4. Drive Format
You can format the USB DISK when connected USB DISK have other file system than FAT32
or simply erase all the USB DISK contents by one time.
This menu item will deactivate when the
USB DISK not properly connected or USB DISK is in recording / playing process.
G
To Next Page
Loading...
Need help?
General
