LOA DERS A ND F EE D NEC K
LOADERS AND FEED NECK
To achieve the maximum
performance of the RIZE ™ you will
need to use a mo toriz ed load er that
force feed s p aintballs into the
RIZE ™ marker, p referab ly the
Rotor™ Load er. Using a slower
mo toriz ed load er or a no n-
mo toriz ed load er will work, b ut the
rate of fire and p erformance will be
red uced.
TO F IT A LOADER ONTO THE
RIZE ™:
1. To fit a load er o nto the RIZE™,
tighten your load er int
o the
adjustable feed neck using a 5/ 32”
A llen key.
2. Load er should now b e held in with a snug fit.
3. There is no maintenance need ed for the feed neck
besides keep ing it clean of b ro ken p aint, d irt and
deb ris.
AIR/ NITRO GEN
AIR / NITROGEN TANK OPTIONS AND INSTALLATION
The RIZE ™ with Comp ressed air and Nitro gen air systems
such as the DY E Throttle® air system and will also
work with CO
2
. Do not use any other comp ressed
gas. The o utp ut pressure fro m the air system has
to b e b etween 4 0 0 – 850 p si. If you are using CO
2
it is essential that the tank is fitted with an anti-
siphon tub e to p revent liq uid CO
2
from
entering the RIZE™.
To install an air system, screw the tank into
the airp ort all the way as far as it will g o.
To remove the air system screw out.
There will b e g as leaking for a few
second s while you screw the
air system
out. Notice that even with the air
system removed there can b e g as
insid e the RIZE™ and it can still fire
a p aintball. A lways treat the
marker as being live and never
po int it to any thing you d on’t
intend to sho ot at!
18
19
W W W . D Y E P A I N T B A L L . C O M W W W . D Y E P A I N T B A L L . C O M
To Next Page
Loading...
