REMOTE BATTERY INSTALLATION
CHARGING THE DRONE BATTERY
1. Make sure the drone is turned off.
2. Connect the USB charging cable to the drone’s charging port.
3. Plug the charger into a USB port. The indicator light on the drone will
stay red while charging and will turn green once fully charged.
Charging time: 40 minutes --- Flying time: approximately 6-8 minutes
CAUTION WHEN CHARGING
1. When charging, place product on a dry, well-ventilated surface and keep
away from heat sources.
2. Always use adult supervision while charging.
3. In order to increase battery longevity, avoid repeat charging and excessive
discharging.
4. As battery temperature is high immediately after flight, charge after cooling
down for higher efficiency.
5. Do not strike or subject battery to hard impacts or sharp surfaces.
6. Do not use any other charger than that which is supplied with this item.
7. Do not use or leave battery near a heat source such as fire or space heater;
exposure to heat may result in reduced performance or in some cases
dangerous conditions.
8. If battery is left in charging state for an extended period of time after being
fully charged, the battery may automatically discharge.
9. Never leave the battery unattended during charging.
10. Do not disassemble battery.
11. Do not submerge battery in water.
DO NOT CHARGE OVERNIGHT OR BEYOND THE CHARGING TIME STATED.
DO NOT LEAVE BATTERY UNATTENDED.
*Battery: Li-Po, 3.7V, 220mAh
5
* Low Battery Signal:
The indicator on the drone
will flash red even after
syncing to the remote.
To Next Page
Loading...
Need help?
General