Protocol AERO 2.0 - User Manual

Questions and Answers

R
roberto35Jul 25, 2025
What to do if my Protocol Drones Aero 2.0 does not respond?
- A
  Alec OliverJul 26, 2025
  If the Protocol Drone Aero 2.0 does not respond, it could be due to a couple of reasons. First, the communication between the controller and the aircraft might not have been properly synchronized during setup. To fix this, turn on the aircraft first, place it on level ground, and then turn on the controller. Another reason might be that the battery power is depleted on either the aircraft, the controller, or both. In this case, charge the aircraft and/or replace the batteries in the controller.
A
Amanda ThomasJul 31, 2025
How to fix low battery alarm on Protocol AERO 2.0 Drones?
- D
  Danielle MoodyJul 31, 2025
  If you are getting a low battery alarm on your Protocol Drones, land the drone as soon as possible and recharge it.
K
Kevin BrightAug 6, 2025
Why Protocol Drones Aero 2.0 will not hover or strafe correctly?
- K
  keith17Aug 6, 2025
  If your Protocol Drone Aero 2.0 will not hover or strafe correctly, there are a couple of potential causes. First, the aircraft might not have been on level ground during synchronization. To resolve this, re-synchronize the aircraft and controller. Second, the trim settings might be incorrect. To fix this, reset the trim buttons on the controller and re-trim the flight controls.
M
Margaret MartinAug 11, 2025
What to do if Protocol Drones response to control inputs intermittent?
- T
  Tammy AriasAug 12, 2025
  If your Protocol Drones' response to control inputs is intermittent or erratic, it is probably because the controller battery power is nearly depleted. Replace the batteries in the controller.
L
Latasha RivasAug 18, 2025
How to restart Protocol Drones if the motors stop running?
- A
  angelajohnsonAug 18, 2025
  If the motors of your Protocol Drones stop running, it could be because a propeller is stuck. In this case, the motors will automatically stop running. To resolve this, pull the throttle down and release it to start the engines.