FLYING THE QUADCOPTER
Step 1: Push the ON/OFF
power switch up.
Step 2: Open the battery
cover and insert the
battery into the power port.
Step 3: Close the battery
cover and turn on the
quad-copter.
Step 4: Push the throttle lever to the highest position, and
then pull it back to the lowest position. There will be one
beep from the transmitter. This shows that the quad-copter
has synced with the remote.
Tips: When syncing your quad-copter keep it
in a horizontal position for stable flight.
1. If the Dronium and the remote do not sync after following the Pre-Flight checklist, reverse the
first two steps of the process. Turn the remote off and unplug the cable from the Dronium.
Then, turn on the remote first and then plug the cable back into the Dronium to turn it on.
Follow with Step 4.
2. Turn on the controller; if, after 30 seconds, it has not recognized the helicopter, turn off
controller to retry synchronization.
3. If quad-copter's LED blinks slowly, it means it has not recognized the controller; please
restart pre-flight procedure.
4. If the Dronium is unsteady in flight, it may not have been able to calibrate horizontally;
Power down both vehicle and remote and restart pre-flight procedure.
NOTE
3
To Next Page
Loading...
Need help?
General
