TAKE–OFF
1. From Idle mode, press the take off button. The
remote will beep and the drone will hover a few
feet off the ground. Then gently advance the
throttle to a desired height and release. The
drone will hover at that height.*
OR
2. From idle mode, gently advance the throttle up
to a desired height and release. The drone will
hover at that height.*
LANDING
1. Press the landing button to lower the drone
to the ground.
OR
2. Push down on the throttle until the drone is
on the ground.
NOTE:
- EMERGENCY LANDING: Press and hold the land
button and the engines will shut off.
* The drone may drift a bit, especially in the first 30
seconds until the altitude sensor gets a good fix on
the position. Some drift is normal.
OPERATION: FLYING THE DRONE
STARTING THE ENGINE; ENGINE IDLE
After calibrating the GPS, move the throttle and direction
sticks in to the lower center corners and release to go
into Idle mode. The blades will rotate but the drone will
not lift.
*The engines will shut off automatically after 10 seconds
if there is no action.
**To shut off the engines manually, press & hold the
take off/landing button.
8
To Next Page
Loading...
Need help?
General
