ORiNOCO
®
802.11n Access Points - Software Management Guide 87
Navigate to CONFIGURATION > DHCP > DHCP Server. The DHCP Server screen appears.
Figure 5-47 DHCP Server
Tabulated below are the ‘DHCP Server’ parameters and method to configure the configurable parameters:
Parameter Description
DHCP Server Status Specifies the status of the DHCP Server functionality on the device. By default, it is disabled.
To configure, select Enable or Disable from the drop down menu.
: If DHCP Server Status is enabled, it is recommended to set the IP address manually
(Static IP Address). See Assigning the IP Address Manually
Max Lease Time The IP address assigned by the DHCP server is valid till the configured maximum lease time.
By default, the Max Lease Time is 86400 seconds. To configure, enter a value in the range
3600-172800 seconds.
DHCP Interface Settings
The DHCP Interface Settings Table contains the following information:
Subnet Mask Specifies the subnet mask forwarded to the client along with the assigned IP address. The
netmask configured here should be greater than or equal to the netmask configured on the
interface. To configure, enter the subnet mask.
Default Gateway Specifies the default gateway address forwarded to the client along with the assigned IP
address. Default Gateway is a node that serves as an accessing point to another network. To
configure, enter the Default Gateway address.
Primary DNS Specifies the primary DNS (Domain Name Server) IP address forwarded to the client. To
configure, enter the Primary DNS address.
Secondary DNS Specifies the secondary DNS IP address to be sent to the client. To configure, enter the
Secondary DNS address.
To Next Page
Loading...
Need help?
General
