ORiNOCO
®
802.11n Access Points - Software Management Guide 88
Click OK and COMMIT, to save the configured parameters.
5.9.1.1 Add an Entry to DHCP Pool Table
To add an entry to the DHCP Pool Table, click Add in the DHCP Server screen. The DHCP Pool Table Add Row screen
appears.
Figure 5-48 DHCP Pool - Add an Entry
Configure the following parameters:
Default Lease Time Specifies the least time provided by the DHCP server, to the DHCP client on that interface.
By default, it is 86400 seconds. To configure, enter a value in the range 3600 to 172800
seconds.
: If the ‘Default Lease Time’ value is greater than ‘Max Lease Time’, then the DHCP
server assigns the Max Lease Time to the DHCP client.
Status Specifies the status of DHCP server functionality over the interface.
By default, it is disabled. To configure, select Enable or Disable from the drop down menu.
DHCP Pool Table
The DHCP Pool Table contains the following information:
Start IP Address Specifies the Start IP Address of the pool.
End IP Address Specifies the End IP Address of the pool.
Delete This parameter allows you to delete the added pool entry.
:
• A pool entry can be deleted but not edited.
• To enable DHCP Server, atleast one pool must be configured.
Parameter Description
Pool Interface Specifies the interface type (ethernet or wireless). The device supports only Bridge mode.
Start IP Address See DHCP Pool Table
To Next Page
Loading...
Need help?
General
