Tsunami MP-8100 Reference Manual 13
1.5.2 Reboot
For some commands, such as Frequency Domain, Radio Mode and others, it’s necessary to commit and reboot the system to
reflect the changes. This can be done by using the reboot command under configure level. For this, follow the procedures
shown below before exiting the configure mode.
1.5.3 Show Command
When you enter show command along with ? at the CLI command prompt, it lists the following feature that you can
configure or view.
When you execute show command in user mode, you will get few commands only. But in privileged mode, all available
commands under show are displayed and can be executed.
You can execute show command only when you are in user mode or privileged mode, but not in Global configuration mode.
System Name# show ?
System Name> enable
System Name# configure
System Name(config)#reboot ?
Possible completions:
<yes(1)/no(2)> Reboot the device. Set 1 to reboot
System Name(config)# reboot 1
System Name> show ?
Possible completions:
hostname Display the Host Name Information
ip Display the Ip Information
licensed-feature Display the license feature Information
system-information Display the System Information
tech-support Display Technical Support Information
To Next Page
Loading...