Proxim Tsunami MP-8100 Series - Device Management

Command Line Interface
Tsunami MP-8100 Reference Manual 50
Pir Ip List Configuration
1.5.5 Device Management
System Name(config-worpqos)# pir-ip-list
System Name(config-worpqos-piriplist)# rowadd 0 ?
Possible completions:
<[Enter]> Execute this command
comment Comment Configuration
entry-status Table Entry Status
ip-address Ip Address Configuration
subnet-mask Mask Configuration
System Name(config-worpqos-piriplist)# rowadd 0 entry-status 4
System Name(config-worpqos-piriplist)# rowadd 0 comment string
System Name(config-worpqos-piriplist)# rowadd 0 ip-address 10.0.0.1
System Name(config-worpqos-piriplist)# rowadd 0 subnet-mask 255.255.255.0
System Name(config-worpqos-piriplist)# rowadd 0 entry-status 4
System Name(config-worpqos-piriplist)#exit
System Name(config-worpqos)#exit
System Name(config)#exit
System Name# show worp-qos pir-ip-list
// WORP QOS PIR IP TABLE CONFIGURATION //
INDEX 1
IP Address : 10.0.0.1
SubNet Mask : 255.255.255.0
Comment : string
Entry Status : enable
System Name(config)# management
System Name(config-mgmt)# ?
Possible completions:
System Name(config-mgmt)# ?
Possible completions:
access-ctrl Access Control Configuration
access-table Access Table Configuration
access-tbl-status To enable or disable the Management Access Table
exit Exits Back to Global Configure Mode
http Http Configuration
read-password SNMP Read Password
read-write-password SNMP Read Write Password
secure-management configure the secure management
snmp-version Configure the SNMP version
ssh SSH Configuration
system-information System Information Configuration
telnet Telnet Configuration
tftp TFTP Configuration
trap-host-table Trap Host Table Configuration
v3-auth-password Authentication password for the authentication protocol
v3-auth-protocol Authentication protocol in SNMPV3
v3-priv-password Privacy (encryption) password for the privacy protocol
v3-priv-protocol Privacy (encryption) protocol in SNMPV3
v3-security-level To select the security leave for snmpv3