Proxim Tsunami MP-8100 Series - Product Package

Command Line Interface
Tsunami MP-8100 Reference Manual 17
RIP Config Table Configuration
Static Route Status and Static Route Table
Static Routes can be configured using the following commands:
To configure the Static Route Status, use the following command:
System Name(config-net-rip)# config-table
System Name(config-net-rip-riptbl)# rowedit 1 authentication-key word
System Name(config-net-rip-riptbl)# rowedit 1 authentication-type none
System Name(config-net-rip-riptbl)# rowedit 1 receive-only no
System Name(config-net-rip-riptbl)# rowedit 1 status enable
System Name(config-net-rip-riptbl)# rowedit 1 version-number v2
System Name(config-net-rip-riptbl)# exit
System Name(config-net-rip)# exit
System Name(config-net)# exit
System Name(config)# exit
RIP Table display when two Ethernet & a Wireless Interface status is Enabled.
System Name# show network rip
// RIP TABLE CONFIGURATION //
Rip Configuration Status : enable
INDEX 1
Interface Name : Ethernet 1
Interface Status : enable
Authentication Type : none
Authentication Key :
Version Number : v2
Receive only : no
INDEX 2
Interface Name : Ethernet 2
Interface Status : enable
Authentication Type : none
Authentication Key :
Version Number : v2
Receive only : no
INDEX 3
Interface Name : Wireless 1
Interface Status : enable
Authentication Type : none
Authentication Key :
Version Number : v2
Receive only : no
System Name(config)# network
System Name(config-net)# static-routes
System Name(config-net-static)#?
Possible completions:
exit Exits Back to Global Configure Mode
static-route-status Static Route Status Configuration
static-route-table Static Route Table Configuration
System Name(config-net-staticroute)# static-route-status enable