Proxim Tsunami MP-8100 Series - Page 25

Command Line Interface
Tsunami MP-8100 Reference Manual 25
1.5.4.3 Ethernet
Enter the following commands to configure the Ethernet parameters:
NOTE: Here, unknown speed and mode indicates that the Ethernet link is down.
1.5.4.4 Wireless
Properties Table
Enter the following commands to configure the wireless properties table parameters in Interface 1.
System Name(config)# ethernet
System Name(config-ether)#?
Possible completions:
exit Exits Back to Global Configure Mode
inactivity-timer Configure Ethernet Inactivity Timer
rowedit Enter row number to edit
System Name(config-ether)# inactivity-timer 450
System Name(config-ether)# rowedit 1 txmodeandspeed 1
System Name(config-ether)#exit
System Name(config)#exit
System Name# show ethernet
// ETHERNET INTERFACE CONFIGURATION //
INDEX 1
Mac Address : 00:20:a6:c1:65:7e
Supported Speed : hundredMbit
Supported Tx Mode : fullDuplex
Tx Mode and Speed : auto
INDEX 2
Mac Address : 00:20:a6:c1:65:7f
Supported Speed : unknown
Supported Tx Mode : unknown
Tx Mode and Speed : auto
Ethernet Inactivity Timer : 450