Proxim Tsunami MP-8100 Series - Page 27

Command Line Interface
Tsunami MP-8100 Reference Manual 27
Worp
Enter the following command to configure Wireless WORP Table parameters in Interface 1.
System Name (config)# wireless
System Name (config-wireless)# mimo
System Name (config-wireless- mimo)#radio 1 ampdu-status enable
System Name (config-wireless- mimo)#radio 1 frequency-extension upper
Frequency extension is configurable only if channel bandwidth is 40MHz
System Name (config-wireless- mimo)#radio 1 guard-interval fullgi-800nsec
System Name (config-wireless- mimo)#radio 1 rx-antennas 7
System Name (config-wireless- mimo)#radio 1 data-streams 1
System Name (config-wireless- mimo)#radio 1 tx-antennas 7
System Name (config-wireless- mimo)#exit
System Name (config-wireless)#exit
System Name (config)#exit
System Name# show wireless mimo
// MIMO CONFIGURATION //
INTERFACE 1
Ampdu Status : enable
Ampdu Maximum Number of Frames : 64
Ampdu Maximum Frame Size : 65535
Amsdu Status : disable
Amsdu Maximum Frame Size : 4096
Frequency Extension : upper
Guard Interval : fullgi-800nsec
Tx Antennas : seven
Rx Antennas : seven
Data Streams : Longer Range
Supported Tx Antennas : 1,4,5
Supported Rx Antennas : 1,4,5