Proxim Tsunami MP-8100 Series - Page 55

Command Line Interface
Tsunami MP-8100 Reference Manual 55
1.5.5.9 Trap Host Table
Enter the following commands to configure the TRAP Host table.
1.5.5.10 Display the Inventory Information
Inventory management provides complete component information of the device. This section describes the version history of
each and every component.
System Name (configure-mgmt)#tftp
System Name (config-mgmt-tftp)#?
Possible completions:
exit Exits Back to Global Configure Mode
file-name TFTP File Name Configuration
file-type TFTP File Type Configuration
operation-type TFTP Operation Type Configuration
server-ip TFTP Server IP Configuration
System Name (config-mgmt-tftp)#server-ip 169.254.128.133
System Name (config-mgmt-tftp)#file-name TQB_image.sei
System Name (config-mgmt-tftp)#file-type image
System Name (config-mgmt-tftp)#operation-type download
System Name (config-mgmt-tftp)#exit
System Name (config)#exit
System Name# show tftp
// TFTP CONFIGURATION //
Server Ip : 169.254.128.133
File Name : TQB_image.sei
File Type : image
Operation Type : none
Operational Status : idle
System Name(config-mgmt)# trap-host-table
System Name(config-mgmt-trap)# rowadd 0 ?
Possible completions:
<[Enter]> Execute this command
comment Comment Configuration
entry-status Entry Status Configuration
ipaddress Ip Configuration
password Password Configuration
System Name(config-mgmt-trap)# rowadd 0 entry-status 4
System Name(config-mgmt-trap)# rowadd 0 ipaddress 169.254.128.133
System Name(config-mgmt-trap)# rowadd 0 comment Default
System Name(config-mgmt-trap)# rowadd 0 entry-status 4
System Name(config-mgmt-trap)#exit
System Name(config-mgmt)#exit
System Name(config)#exit
System Name# show traphost
// TRAP HOST TABLE CONFIGURATION //
INDEX 1
Ip Address : 169.254.128.133
Password : ******
Comment : Default
Entry Status : enable