Proxim Tsunami MP-8100 Series - Page 82

Event Log Error Messages
Tsunami MP-8100 Reference Manual 82
CRITICAL For WORP - ReTransmission
Count: ‘Count Value’ & Msg
Response Time:’ Response
Time Value’ values are not valid
Retransmission count and
Message Response time values
configured are not valid.
Check your configuration
and try again to commit
the changes.
CRITICAL Security Profile: ‘Profile Name’:
In High Throughput Modes,
WEP/TKIP Encryption Types are
not Supported
Reduce the throughput rates to
enable encryption with WEP or
TKIP.
If Security is required,
throughput rate has to be
configured to a lesser
value.
CRITICAL Security Profile: ‘Profile Name’:
TKIP/AES Encryption Types will
accept only 16 Ascii characters
or 32 Hex digits
Security Key for TKIP or AES
encryption type will accept only
16 ASCII characters or 32
Hexadecimal digits for Security
Profile mentioned.
Check your configuration
and commit the changes
again.
CRITICAL Security Profile: ‘Profile Name’:
All the 4 Encryption Keys are
not of Same Length
For the security profile
mentioned, make sure all the
four encryption keys are of the
same length.
Check your configuration
and commit the changes
again.
CRITICAL Wireless Interface Invalid
Regulatory Domain
Invalid Regulatory Domain is set
for wireless interface
Check your configuration
and the license file before
retrying.
CRITICAL Country Code Not Set Country Code is not set. Set Country code to
enable wireless.
CRITICAL RADIO [‘radio number’]
CALIBRATION DOESNOT
MATCH WITH MFG DATA
REGDOMAIN
Regulatory Domain does not
match with the radio
calibration.
Check your license file
and the configuration
before retrying.
CRITICAL Failed in Committing Wireless
Parameters.
Correct the Configuration
and Commit if anything is
found invalid/Reboot the
device(After rebooting,
device will come with old
configuration).
CRITICAL Failed in Wireless Initialization. Reboot the Device.
ALERT Wireless: Tx Rate <data rate>,
Power Level <power level>dBm
Not required.
ALERT Security Profile <profile name>
is Disabled - No Security
Configuration is Applied
Not required.
ALERT Soft Reset Parameter Modified Not required.
ALERT End of DFS Wait Period on
Channel <channel number>
for Device ath0
Not required.
Error Type Message Description Corrective Action