Need help?Do you have a question about the Proxxon PD 250/E and is the answer not in the manual?
General| Purpose | Metalworking |
|---|---|
| PC connected | - |
| Product color | Black, Green, Yellow |
| Feed speed (max) | 0.1 mm/revolution |
| Feed speed (min) | 0.05 mm/revolution |
| Cross slide travel | 43 mm |
| Lathe bed material | Cast iron |
| Chuck number of jaws | 3 |
| Cutting thread (max) | 1.5 mm |
| Cutting thread (min) | 0.5 mm |
| Run-out without chuck | 1/100 mm |
| Rotational speed (max) | 3000 RPM |
| Rotational speed (min) | 300 RPM |
| Distance between centers | 250 mm |
| Number of cutting thread steps | 7 |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
Weight and Dimensions| Depth | 560 mm |
|---|---|
| Width | 270 mm |
| Height | 170 mm |
| Weight | 12000 g |
Specific safety instructions and warnings applicable to lathe operation.
Cautionary advice regarding electrical shock and accidental starting during installation.
Essential safety checks and operational procedures before starting the machine.
Procedure for engaging and disengaging the automatic feed system.
Method for calculating the maximum permissible spindle speed based on cutting speed.
Procedure for adjusting spindle speed by shifting the V-belt.
Instructions for securely clamping work pieces in the lathe chuck.
Guide to selecting and fitting change gears for metric thread cutting.
Detailed procedure for fitting change gears onto the gear arm.
Steps for cutting threads using a turning tool and automatic feed.
Method for cutting high-quality threads using the top slide.
To Next Page
