Need help?Do you have a question about the Proxxon FD 150/E and is the answer not in the manual?
General| Swing over bed | 150 mm |
|---|---|
| Distance between centers | 300 mm |
| Spindle bore | 8.5 mm |
| Voltage | 220 - 240 V |
| Top slide travel | 50 mm |
| Spindle speeds | 500 – 5, 000 rpm |
| Motor power | 150 W |
Highlights that an untidy working area increases the accident risk.
Read all safety warnings and instructions to avoid injury.
Ensure the device is fastened to a solid surface and stable.
Check the device for signs of damage before each use.
Do not make any changes or manipulations to the machine.
Wear protective goggles, hearing protection, and suitable clothing.
Maintain attentiveness, avoid tool overloading, handle cables carefully.
Always wear hearing protection and safety glasses.
Ensure chuck keys are removed; tighten turning jaws securely.
Ensure maintenance, stop if vibration occurs, use suitable cutters.
Disconnect mains plug for adjustments/maintenance to prevent unexpected start-up.
Ensure hood is closed when lifting; secure machine to a stable surface.
Set up on a stable, level, vibration-free surface.
Correct tool, sharpness, height, and speed are crucial for proper turning.
Disconnect mains plug before working in the gear case.
Avoid overloading; check rating plate matches mains supply.
Always wear hearing protection and safety goggles while working.
Only operate with a folded-down chuck guard; do not use if defective.
Disconnect mains plug for all adjustment and maintenance work.
To Next Page
