Measurement modes
The following measurement modes are available for horizontal machine configurations:
IntelliSWEEP – This is the measurement mode used to measure standard coupled machines. It detects
error influences such as coupling play, rough rotation and environmental vibration, and automatically
eliminates the induced errors.
Multipoint – This is the mode used to measure nonrotatable shafts, sleeve bearings [journal (radial)
bearings], white metal bearings , shafts that are hard to turn, shafts with herky-jerky rotation, situations
with long spans or severe misalignment that will readily cause the beam to fall out of range
Static – This mode is used to measure uncoupled shafts.
The desired measurement mode is selected while in the measurement screen.
Tap the measurement mode header [1] to access the measurement mode carousel.
Tap either the top or bottom arrow to select desired measurement mode.
FictionSoft 19
(Undefined variable: General.UserGuideTitle)
To Next Page
Loading...