sensALIGN laser
The semiconductor laser diode emits a ray of red light (wavelength 635 nm) which is vis-
ible where it strikes a surface. The Class 2 laser beam is emitted with a diameter of approx.
5 mm (3/16”).
sensALIGN laser is turned on by pressing and holding the On/Off switch briefly. The
“beam active” LED lights red.
With sensALIGN laser on, DO NOT stare into the laser beam!
The beam is adjusted during set-up by changing its vertical and horizontal angles using the position
thumbwheels, so that the beam strikes the sensALIGN sensor lens perpendicular to the lens surface.
sensALIGN laser is water and dust resistant (IP 65). The internal optics and electronics are internally
sealed, preventing possible contamination.
4 Edition: (Undefined variable: General.Edition)
(Undefined variable: General.UserGuideTitle)
To Next Page
Loading...