Prusa Research ORIGINAL i3 MK3S+ KIT - Table of Contents

Table of contents
2 Product details 6
3 Introduction - Glossary, Disclaimer, Safety instructions, Licenses 6
4 Original Prusa i3 MK3S+ printer 8
5 Original Prusa i3 MK3S+ printer kit 9
6 First steps 10
6.1 Printer unpacking and proper handling 10
6.2 Printer assembly 11
6.3 Setup before printing 11
6.3.1 Calibration flow and wizard 12
6.3.2 Preparation of the spring steel sheet 13
6.3.3 Increasing the adhesion 18
6.3.4 Selftest (kit only) 18
6.3.5 Calibrate XYZ (kit only) 20
6.3.6 Calibrate Z 23
6.3.7 Mesh bed leveling 24
6.3.8 Loading the filament into the extruder 25
6.3.9 First layer calibration (kit only) 26
6.3.10 Fine tuning the first layer 29
7 Printing 30
7.1 Removing objects from the printer 30
7.2 Printer Control 31
7.2.1 LCD screen 31
7.2.2 Controlling the LCD screen 31
7.2.3 Print statistics 32
7.2.4 Fail stats 32
7.2.5 Normal vs. Stealth mode 33
7.2.6 Factory reset 33
7.2.7 SD card sorting 34
7.2.8 Testing if file (.gcode) is complete 34
7.2.9 LCD layout 35
7.2.10 Print speed versus print quality 37
7.2.11 USB cable and Pronterface 38
7.2.12 Power panic 39
7.2.13 Crash detection 40
7.2.14 Temperatures 40
7.2.15 Voltages 40
7.2.16 Safety timer 41
7.2.17 Beeper settings 41
7.2.18 Language settings 41
7.2.19 Dump memory 41
7.3 Printer addons 42
7.3.1 Different nozzles 42
7.3.2 Original Prusa Multi Material Upgrade 2S 43
7.3.3 Connecting Raspberry Pi Zero W 44
8 Advanced Calibration 45
8.1 Steel sheet profiles 45
8.2 Nozzle diameter setup 45
4