PS Automation PSF-Q User Manual

9
11. Signalisation and functions
11.1 DIP switches
S1
Function
1
2
3
4
5
6
7
8
Signal
Set value
Position feedback
Voltage
On
On
Off
Off
Off
On
Off
On
Current
Off
Off
On
On
On
Off
On
Off
S2
Function
1
2
3
1)
4
1)
5
6
6
8
9
1)
10
Control via set value
On
Control via binary inputs
Off
Output valve shaft counterclockwise (CCW) with
increasing set value
On
Output valve shaft clockwise (CW) with increasing
set value
Off
Automatic
Commissioning
Close with torque /
Open with torque
On
On
Off
Close with torque /
Open with travel
2)
On
On
On
Manual
commissioning
Close with torque /
Open with required rotation angle
On
On
On
Set value range: 0-10 V / 0-20 mA
On
On
On
Set value range: 2-10 V / 4-20 mA
Off
On
On
Set value / Split-Range 5-10 V/10-20 mA
On
On
Off
Set value / Split-Range 6-10 V/12-20 mA
Off
On
Off
Set value / Split-Range 0-5 V/0-10 mA
On
Off
On
Set value / Split-Range 2-6 V/4-12 mA
Off
Off
On
Torque end position with counterclockwise rotating
valve shaft (CCW)
On
Torque end position with clockwise rotating valve
shaft (CW)
Off
Valve curve LINEAR setpoint/position
Off
Valve curve QUICK OPENING Setpoint/position
On
1)
After changing the switches S2-3, S2-4 and S2-9, perform re-calibration to activate the new operating mode!
2)
The position will be defined by torque during commissioning. During operation the actuator will stop at the found position (see 11.5).

PS Automation PSF-Q Specifications

General

Brand	PS Automation
Model	PSF-Q
Category	Controller
Language	English