Secondary Speaker
1. Disconnect the Secondary Speaker from mains power outlet. Position a tool with pointed tip (for example, paper clip) to reach and
contact the SERVICE tact switch – do not touch the SERVICE tact switch with the tool yet.
2. Wait for 30 seconds and then reconnect the power.
3. As soon as the Status Indicator LED turns Red, press and hold the SERVICE tact switch with the pointed tip of the tool. The Status
Indicator LED will immediately turn Green and then back to Red - continue to hold for 30 seconds the SERVICE tact switch with the
pointed tip of the tool.
4. After 30 seconds, the Status Indicator LED will begin to blink red – release hold of SERVICE tact switch.
5. The Status Indicator will turn Green. This indicates that the factory reset of the Secondary Speaker is completed and is now at Hotspot
mode ready to be configured and paired.
Important Note Releasing >II (Play/Pause) or SERVICE tact switch before the Status Indicator LED blinks Red will cancel the factory
reset process and leave the Alpha iQ at Upgrade Mode. Just start again the procedure for Factory Reset.
Positioning
I. As symmetrically as possible, place your Alpha iQ Primary and Secondary Speakers at a comfortable listening location with no
obstructions at the front or back.
II. We recommend at least three inches of clearance around the back of both speakers. Good air circulation is required for heat dissipation,
and to ensure proper performance of the rear-firing ports. Similar positioning and clearance should be used for both speakers. To maintain
high resolution performance and consistent transmission, the speakers should be placed within 15 ft from each other.
For more detailed information about speaker placement, please visit www.psbspeakers.com.
Protecting your Investment
For long lasting enjoyment of your PSB product, you should respect their limits and avoid excessive volume levels for music or movie
playback. Excessive volume levels can damage all types of speakers. If your speakers are pushed to excessive volume levels, they could be
driven into “clipping”, which may result in severe and/or permanent damage.
When listening to your speakers at loud levels, listen carefully for any signs of harsh, distorted midrange and diminishing precision. If
detected, turn the volume down immediately.
NEVER TEST PEAK LISTENING LEVELS OF YOUR SPEAKERS BY TURNING THE VOLUME TO THE MAXIMUM LEVEL.
Care and Cleaning
For safe, sanitary use, it is essential to maintain and clean your speakers periodically. However, excessive cleaning may cause damage
and jeopardize the longevity of the product. When not in use, avoid storing in extreme hot or cold temperatures and humidity, and avoid
exposure to liquids.
Packaging
We highly recommend retaining all product packaging for any necessary transport. To transport, carefully place the speakers into their
original packaging and close each panel.
To Next Page
Loading...
