PTF 3207A - Page 23

Go to Contents Precise Time and Frequency, Inc., 50L Audubon Road, Wakefield, MA 01880, USA ptf 3207A rev G
Tel: +1-781-245-9090 e-mail: info@ptfinc.com www.ptfinc.com pg. 23
 Press MENU - this will display the menu screen options. To scroll through menu items press the
(RIGHT ARROW) key. The cursor on the left side of the screen will highlight each menu
item in turn.
TIP: To more rapidly move through the menu items, you can use the (DOWN ARROW)
key. This will page through the screens 4 items at a time. When the screen containing
the item you require appears, you can use (RIGHT ARROW) and (LEFT
ARROW) keys to place the cursor next to the required item.
To setup STATIC network parameters
 Scroll through the menu items as described above until the cursor highlights menu item IP
 Press ENTER - the IP address edit screen is presented. Enter the new IP address in dot format
using three digits for each number e.g. 192.168.000.023 and then press the ENTER key. This
will store the new value.
TIP: To exit without storing the new value press the MENU key.
 Now scroll through the menu items as described above until the cursor highlights menu item
NMASK.
 Press ENTER - the Netmask edit screen is presented. Enter the new Netmask in dot format
using three digits for each number e.g. 255.255.255.000 and then press the ENTER key.
 Next scroll through the menu items as described above until the cursor highlights menu item
GWAY.
 Press ENTER - the Gateway edit screen is presented. Enter the new Gateway in dot format
using three digits for each number e.g. 192.168.000.001 and then press the ENTER key.
If DHCP was already OFF, the new static values will be set. If DHCP was ON, it is necessary to
scroll to the DHCP item to turn DHCP off as follows:
 Scroll through the menu items until the cursor highlights menu item DHCP. Press ENTER - the
DHCP edit screen is presented. The two choices of ON and OFF are presented, with the cursor
pointing to the current selection - ON. Using the (RIGHT ARROW) and (LEFT ARROW)
keys highlight the OFF selection, then press the ENTER key. The new selection will be stored
and the STATIC IP parameters will be invoked.
To setup DYNAMIC network parameters
 Scroll through the menu items until the cursor highlights menu item DHCP. Press ENTER - the
DHCP edit screen is presented. The two choices of ON and OFF are presented, with the cursor
pointing to the current selection - OFF. Using the (RIGHT ARROW) and (LEFT