Go to Contents Precise Time and Frequency, Inc., 50L Audubon Road, Wakefield, MA 01880, USA ptf 3207A rev G
Tel: +1-781-245-9090 e-mail: info@ptfinc.com www.ptfinc.com pg. 22
Configuring Ethernet Settings
The following additional steps are required to make the ptf 3207A operational on a network. Make the
ptf 3207A operational on a network if you plan on managing the ptf 3207A remotely over the network
or distributing timing information from the ptf 3207A over the network
Insure a network cable is plugged in and connected to the network.
First determine the current network settings of the ptf 3207A by pressing keys on the front panel
keypad as follows:
Press MAIN - this will display the main status screen options. To scroll through available
options press the (RIGHT ARROW) key. The cursor on the left side of the screen will
highlight each status screen option in turn.
Press the number 7 - this will select the system network parameter status screen
OR
Move the cursor by pressing the (RIGHT ARROW) key until the cursor is pointing to
selection number 7, and then press ENTER
The system network status screen will be displayed. On the left hand column the set STATIC
parameters are displayed. If DHCP is ON the dynamically allocated parameters will be displayed in the
right column. If DHCP is OFF the dynamic parameters will be replaced by ---.---.---.---. See the examples
below:
DHCP ON example;
IP Addr 192.168.000.023 192.168.000.010
Netmask 255.255.255.000 255.255.255.000
Gateway 192.1658.000.001 192.168.000.001
DHCP OFF example;
IP Addr 192.168.000.023 - - -.- - -.- - -.- - -
Netmask 255.255.255.000 - - -.- - -.- - -.- - -
Gateway 192.1658.000.001 - - -.- - -.- - -.- - -
If the network parameters are not as you wish, you can change them by pressing keys on the front
panel keypad as follows:
To Next Page
Loading...