Go to Contents Precise Time and Frequency, Inc., 50L Audubon Road, Wakefield, MA 01880, USA ptf 3207A rev G
Tel: +1-781-245-9090 e-mail: info@ptfinc.com www.ptfinc.com pg. 26
*********************************************************************
Connecting to the Ethernet Port (TELNET - port 23)
The Ethernet port provides remote access to the ptf 3207A’s command line interface. Complete the
following steps to connect to the Ethernet (telnet) port.
Set up the Ethernet parameters as per the section " Configuring Ethernet Settings " above
Open a telnet session from your PC to the ptf 3207A.
Log in as user name “admin” and password, “ptf_pwd”. Press Enter on your keyboard to get to
the initial entry screen.
Once connected, press ? followed by the Enter key on your keyboard to display the standard
menu commands shown on the next page.
To display the extended help commands type:
showptf<ENTER>
Tip: If the telnet software has trouble communicating, verify the Ethernet settings.
Multiple Telnet Sessions may be active at one time. Each will be allocated a separate session ID and
each will be individually timed out if the timeout function is active
Command Line Interface Command Format.
The format for commands on both the serial and telnet command interfaces is as follows:
3 character command, space, new value[ENTER] << sets new value
or
3 character command, space, help[ENTER] << displays additional help for the command
or
3 character command[ENTER] << displays current value
Example:
A01[SPACE]fixed[ENTER] << sets the positioning mode
to fixed
Note: There are some special commands that can be entered using just the command name e.g.
STATUS[ENTER]. These can be easily identified as they do not have a value in the value column.
To Next Page
Loading...