10
Hardware Needed
The following hardware is necessary to complete a normal installation.
Depending on the construction of the site and other considerations,
other hardware may be required.
A. Red Head Concrete Wedge Anchors
B. Tapcon Concrete Anchors +
C. Hammer Set Concrete Anchors
D. Self Tapping Screws +
E. Sheet Metal and Wood Screws +
F. Drywall Screws +
G. Toggle Bolts +
H. Machine Washers +
I. Plastic Wall Anchors +
J. Heavy Duty Self Drilling Drywall Anchor+
K. Sheet Metal Rivets +
L. Screwhead Mounting Wire Ties +
M. Cable Clamps and Mounts +
N. Caddy Clips +
O. 18 AWG Spade Connectors
P. 3M U-Type Connectors (UR2, UY2, UG) *
Q. Wire Nuts +
R. Electrical Tape
S. PL Premium Construction Adhesive
T. Silicone Sealant – Heavy Duty Outdoor
U. Fire Barrier Sealant
V. Panduit Wire Raceway
W. Wire Pulling Lubricant
X. Conduit Compression Fittings/Mounts +
Y. Flexible Conduit
Z. Electrical Conduit with Sweep 90 Bends
+ Note: Assorted lengths, sizes, and types will be needed of these.
* Note: Items shown with an asterisk are sold by PTI Security Systems.
Mounting Hardware Recommendations
Surface Type for Mounting Recommended Mounting Hardware
Drywall between Studs Self Drilling Drywall Anchors or Toggle Bolts
Drywall on Studs Self Tapping Drywall Screws
Stucco Toggle Bolts
Wood Drywall Screws
Sheet Metal Self Tapping Sheet Metal Screws
Hollow Block Tapcon Concrete Anchors or Toggle Bolts
Brick or Solid Block Tapcon Concrete Anchors or Concrete Wedge Anchors
Masonry or Concrete Tapcon Concrete Anchors or Concrete Wedge Anchors
All anchors should be size #8 head with a length of 1½ inches or longer (based on wall depth)
To Next Page
Loading...
