12
TROUBLESHOOTING
FAULT TREATMENT
The Backpack Vacuum
cleaner will not turn “On”.
Remove the power plug and then reinsert into the Mains power
supply.
Check that the On/Off switch is in the ‘ON’ position.
The Backpack Vacuum
performance is deteriorating.
Check the Backpack to ensure there are no blockages. Please
clear any blockages that may be found. (Important: always
first remove the plug from the Mains power supply).
Check the cloth filter bag (inlet and exhaust) to see if it needs to
be cleaned or replaced.
The cleaner makes an
abnormal sound when
switched on.
Check the Backpack to ensure there are no blockages. Please
clear any blockages that may be found. (Important: always first
remove the plug from the Mains power supply).
The cleaner has no suction, it
turns off after a few minutes
and does not turn back on.
Check for any blockage in the hose, rod, floor tool restricting
the airflow. Remove blockage and allow approximately 30-60
minutes for the motor to cool down before it can be used again.
(Important: always first remove the plug from the Mains power
supply).
To Next Page
Loading...
