5PULLMAN BACKPACK PV500
ASSEMBLY
Assembling the Hose and Floor Tools
ALWAYS SWITCH OFF YOUR BACKPACK AND REMOVE THE PLUG FROM THE MAINS POWER
SUPPLY BEFORE CLEANING YOUR APPLIANCE, ASSEMBLING, WHEN NOT IN USE OR ATTEMPTING
ANY MAINTENANCE TASK.
CONNECTING THE HOSE
1.
To fit the hose, insert into the hose inlet at the top
of the Backpack. Turn the hose end until it locks
into place.
2. To remove the hose, twist the hose end until it
loosens.
FITTING THE 2-PIECE ROD AND FLOOR TOOL
1. Connect the 2-piece rod together.
2. To fit the floor tool to the rod, gently insert the rod
into the top of the floor tool as shown.
NOTE: THE GULPER FLOOR TOOL IS IDEAL FOR CLEANING
ON CARPETS AND HARD FLOORS.
3. To fit the rod to the handle, gently insert the end
of the handle into the top of the rod.
To Next Page
Loading...
