PAGE 19
RECOMMENDED MAINTENANCE
316REV.030430
Winch gear train lubricating oil should be changed after the initial six months or 50 hours of operation, whichever
comes first. Lubricating oil should then be changed every 12 months or 500 operating hours, whichever comes first.
Hydraulic system fluid should be changed at least once every 12 months.
For optimum performance over an extended period of time, the following preventive maintenance service should
be done every 12 months or 500 operating hours, whichever comes first:
1) Disconnect all hydraulic hoses and remove the winch from its mounting.
2) Disassemble the winch as per instructions.
3) Discard and replace all O-rings and oil seals.
4) Clean all parts and inspect for wear and damage as per instructions. Replace worn or damaged
parts as required.
5) Reassemble the winch as per instructions.
6) Follow INSTALLATION and OPERATING INSTRUCTIONS when returning winch to its mounting.
When ordering parts for the PULLMASTER Model M5 planetary winch, always quote the complete model and serial
numbers of the unit.
MODEL # __________________
SERIAL # __________________
PULLMASTER WINCH CORPORATION reserves the right to change specifications and the design of PULLMASTER
planetary winches at any time without prior notice and without incurring any obligations.
To Next Page
Loading...
