PAGE 18
SERVICE INSTRUCTIONS CONTINUED
4) DISASSEMBLY OF BRAKE PLATES ONLY:
If removal of Brake Piston and Hydraulic Motor is not necessary, proceed as follows:
4.1) Disconnect Brake Hose item 852
4.2) Remove 12 Hex Head Capscrews item 537 and Lock Washers item 541, from Motor Adaptor item
800. It is recommened that the capscrews be unscrewed, one turn at a time, until spring pressure has
been released.
4.3) Carefully withdraw Motor Adaptor item 800, complete with Brake Spacer item 712 and Motor item
850, from Brake Housing item 712.
4.4) Remove 12 Friction Plates item 715 and 13 Divider Plates item 713. Inspect for damage or wear.
Plates should be flat and smooth. Plates should not show heat discoloration. Paper material on
friction plates should be intact and grooved. If any damage is detected, replace friction and divider
plates as a set.
DAMAGED FRICTION OR DIVIDER PLATES WILL REDUCE BRAKING
CAPACITY AND ALLOW THE LOAD TO DROP, CAUSING PROPERTY
DAMAGE, SEVERE INJURY OR DEATH. SOLVENT MAY DAMAGE THE
FRICTION PLATES. DO NOT USE SOLVENT TO CLEAN THE FRICTION
PLATES. PERFORM THOROUGH INSPECTION AND, IF NECESSARY,
REPLACE FRICTION AND DIVIDER PLATES AS A SET.
DANGER
354 REV.030819
To Next Page
Loading...
