Pullmaster M6 Series - Page 82

PAGE 29
* Performance specifications are based on standard hydraulic motor with 1/2 inch diameter wire rope.
247 REV.051117
APPENDIX A
POUNDS
(KILONEWTONS)
DRUM
CODE
CABLE DRUM SIZES
INCHES
(MILLIMETERS)
BARE FULL BARE FULL
BARREL FLANGE LENGTH 1/2 inch 7/16 inch 3/8 inch DRUM DRUM DRUM DRUM
FEET/MINUTE
(METERS/MINUTE)
LUBRICATING
OIL
VOLUME
REQUIRED
U.S.
GALLONS
(LITERS)
LINE PULL
AT MAXIMUM
PRESSURE*
LINE SPEED
AT MAXIMUM
VOLUME*
WIRE ROPE STORAGE
FEET
(METERS)
-1 7.0 11.5 8.0 152 166 227 8500 5795 116 170 0.4
(178) (292) (203) (46) (51) (69) (37.8) (25.8) (35) (52) (1.5)
-2 7.0 13.5 8.0 231 297 375 8500 4904 116 201 0.4
(178) (343) (203) (70) (91) (114) (37.8) (21.8) (35) (61) (1.5)
-4 7.0 13.5 12.0 347 445 562 8500 4904 116 201 0.6
(178) (343) (305) (106) (136) (171) (37.8) (21.8) (35) (61) (2.3)
STANDARD REDUCTION RATIO
'A' REDUCTION RATIO
-1 7.0 11.5 8.0 152 166 227 3790 2584 249 366 0.4
(178) (292) (203) (46) (51) (69) (16.9) (11.5) (76) (111) (1.5)
-2 7.0 13.5 8.0 231 297 375 3790 2186 249 432 0.4
(178) (343) (203) (70) (91) (114) (16.9) (9.7) (76) (132) (1.5)
-4 7.0 13.5 12.0 347 445 562 3790 2186 249 432 0.6
(178) (343) (305) (106) (136) (171) (16.9) (9.7) (76) (132) (2.3)
'B' REDUCTION RATIO
-1 7.0 11.5 8.0 152 166 227 7000 4773 135 199 0.4
(178) (292) (203) (46) (51) (69) (31.1) (21.2) (41) (61) (1.5)
-2 7.0 13.5 8.0 231 297 375 7000 4038 135 235 0.4
(178) (343) (203) (70) (91) (114) (31.1) (18.0) (41) (72) (1.5)
-4 7.0 13.5 12.0 347 445 562 7000 4038 135 235 0.6
(178) (343) (305) (106) (136) (171) (31.1) (18.0) (41) (72) (2.3)