Pullmaster M8 Series - Explanation of Model Coding

PAGE 3
X - XX - XX - XX X - X XXXX
M
75
EXPLANATION OF MODEL CODING
BASIC UNIT SERIES
M = Equal Speed
SIZE OF UNIT
REDUCTION RATIO
Only used for non standard reduction ratios
TYPE OF BRAKE
-7 Automatic brake, clockwise drum rotation, external circulation flow
-8 Automatic brake, external brake release, clockwise drum rotation,
external circulation flow
-9 Automatic brake, external brake release, counterclockwise drum
rotation, external circulation flow
-10 Automatic brake, counterclockwise drum rotation, external
circulation flow
HYDRAULIC MOTOR
-191 Hydraulic motor, 3 inch gear section (12.3 cubic inch displacement)
(Other gear sections for this motor are optional)
DRUM SIZE
-1 16 inch drum diameter X 32 inch flange diameter X 20 inch length
-4 14 inch drum diameter X 35 inch flange diameter X 36 inch length
OPTIONS
DESIGN REVISION
SPECIFICATION NUMBER
Describes features not identified by preceding codes
NOTE: Clockwise and counterclockwise drum rotation is the direction of rotation for pulling or hoisting,
established by looking at the hydraulic motor.
354 REV.030819