Puloon LCDM-2000 - Page 28

PULOON Technology Inc.
LCDM-2000
- Is DIV SENSOR 1 / 2 normal?
- Is GAP of SHAFT DIVERTER ASS’Y SHAFT ASS’Y CASH
FEED proper?
- Is idle roller rotation in GUIDE CASH FEED 5 ASS’Y normal?
Check Point
Jam in DIV SENSOR partDetail
- Try again after checking above situation.
- In case of interference between SHAFT DIVERTER ASS’Y &
SHAFT ASS’Y CASH FEED 3, Adjust location of SOLENOID
PIN( Please refer to below picture)
- Replace ASS’Y in case of idle roller rotation problem in GUIDE
CASH FEED 7 ASS’Y.
Management
36, 42CODE