Pulsar 2 Pro - Page 69

Helion 2 Prothermal imagers feature video recording and photography of the image being
observed to the internal memory card.
Before using this feature please set the date and time (see General Settings section).
The built-in recorder operates in two modes – Video and Photo:
Video mode. Video recording
1.
Switch to Video mode by pressing and holding the REC (7) button.
2.
The icon and the remaining recording time in HH:MM (Hours:Minutes) format are
displayed in the upper left corner, for example 12:10.
3.
Press the REC (7) button briefly to start video recording.
4.
When the video recording starts, the icon will disappear and the REC icon and timer
in MM:SS (Minutes:Seconds) format will appear .
5.
Pause and resume recording video with a short press of the REC (7) button.
6.
Stop recording video with a long press of the REC (7)button.
7.
Video files are saved to the built-in memory card after the video recording has been
stopped.
8.
Press and hold theREC (7) button to switch between the Videoand Photomodes (Video-
> Photo-> Video…)
Photo Mode. Capturing an image
1.
Switch to the Photomode by pressing and holding the REC (7) button.
2.
Press the REC (7) button briefly to take a photo. The image freezes for 0.5 sec while the
photo is saved to the internal memory.
3.
In the top left corner of the display you will see a camera icon and the number of
pictures you are able to take. If the number is less than 100 the actual number will be
shown (i.e. 98) but if more than 100 pictures can be taken >100 will be displayed next to
the icon .
Notes:
You can enter and operate the menu during video recording.
The counter for multimedia files cannot be reset.
Recorded videos and photos are saved to the internal memory card in the format
img_xxx.jpg (photos); video_xxx.mp4 (videos) where xxx is a three-digit counter for
videos and photos.
Warning:
The maximum duration of a recorded file is five minutes. After this time expires, a video is
recorded into a new file. The number of recorded files is limited by the capacity of the
device's internal memory.
Regularly check the free capacity of the internal memory and move recorded footage to
other storage media to free up space on the internal memory card.